Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 12:09 22 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Guest Book : eSmart-3 solar charger

Author Message
ptrott

Newbie

Joined: 08/04/2008
Location: Australia
Posts: 15
Posted: 09:45am 16 Jun 2022
Copy link to clipboard 
Print this post



eSmart3 (40A), also sold as Vevor & Ipanda.

Looking for someone who knows how to set the user defined parameters on this charger for charging LiFePO4 batteries please.
The terminology used in the settings is I think for lead acid, so there are things I don't know what to set to to make them inoperable when charging LiFePo4.

The following are the parameters as listed in the menu, and the figures I think might be right:

The parameters that I can set are as follows:
Constant Voltage:   (14.2)
Float Voltage:          (12.6)
Boost Voltage:         (14.6)
Boost Charge Time: (6 min)
Bat. O/voltage:         (14.7)
Bat. O/voltage recovery: (14.2?)
Bat. U/voltage:         (12.5)
Bat. U/voltage recovery: (12.5?)
Max. discharge current: 100A
Maximum charge current: 40A


The battery is 12V, 135AH, 100A max in & out.

Cheers  
Cheers,
Phill.
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024