Guru
Joined: 18/10/2016
Location: AustraliaPosts: 874
| Posted: 12:12pm 03 Jul 2025 |
Hello all.
Well; I set up an account and uploaded my two STL files.
Four copies of the two items is priced at Au$137. A bit steep for about $15 worth of filament (that I already have). Well worth it if you don't have a printer - but I do.
(I suspect the rate is higher because I ticked the box to say that they were complex shapes).
I think I'll print some PLA, paint them, and try my hand with ASA in warmer weather.
The items are completely non-load bearing but they do clip onto cylindrical hinges. They will be held in place by silicon glue. They are shaped so that there is very little force on them at all.
They are to provide a 60 degree chamfer to four bulky hinges so they cannot be climbed by a five year old child to access the swimming pool.
In practice the chamfers will never be climbed but, by law, they have to be there.
(we do take the safety aspects seriously)
Thanks for your contributions.
Cheers,
Andrew