TheBackShed.com

Home	JAQForum Ver 24.01
Log In or Join
Active Topics
Local Time 00:56 28 Jun 2025	Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : Opto-coupler for DIs

Author

Message

PhenixRising
Guru

Joined: 07/11/2023
Location: United Kingdom
Posts: 1324

Posted: 07:18am 24 Jun 2025

Copy link to clipboard

Print this post

I am using the PC817 for digital inputs. Would an If ~5mA suffice? The datasheet warns about <1mA and I want to be safe.

PC817.pdf

phil99

Guru

Joined: 11/02/2018
Location: Australia
Posts: 2566

Posted: 08:21am 24 Jun 2025

Copy link to clipboard

Print this post

Quote Current transfer ratio (CTR : MIN. 50% at IF=5 mA, VCE=5V)

So it appears the output load can be up to 2.5mA for a drive of 5mA.
If the supply on the output side is 3.3v and the load resistor is 3.3kΩ just 1mA can flow so it should be ok.

Edit.
Fig.6 Current Transfer Ratio vs. Forward Current shows best CTR @ If = 2.5mA.
Edited 2025-06-24 18:29 by phil99

PhenixRising
Guru

Joined: 07/11/2023
Location: United Kingdom
Posts: 1324

Posted: 08:50am 24 Jun 2025

Copy link to clipboard

Print this post

Cheers Phil. 2.5mA feels good

Volhout
Guru

Joined: 05/03/2018
Location: Netherlands
Posts: 5016

Posted: 10:23am 24 Jun 2025

Copy link to clipboard

Print this post

Phenix,

Speed on these PC817 is not overwhelming.
For more speed use digital isolators, or digital optocouplers.

Volhout

PicomiteVGA PETSCII ROBOTS

PhenixRising
Guru

Joined: 07/11/2023
Location: United Kingdom
Posts: 1324

Posted: 10:54am 24 Jun 2025

Copy link to clipboard

Print this post

Cheers, Harm.

These are only 24V signals from proximity sensors. I software debounce anyway so speed isn't an issue.

Print this page

To reply to this topic, you need to log in.