'my attempt PICAXEFinal.bas  22/9/2025
'Overview: If Trig is 0 then loop and wait
'If trigger goes high start 2 min timer
'at end if still high set output C2 High for 2 min
'repeat until trigger goes low then output goes low
'at end of 2 min timing cycle.
'
#picaxe 08m2 'Identify the PICAXE being used as an 08M2.
#no_data     'No data tranfer required

Symbol X=b0 'Variable for the timer loop needs to be here ???

OUTPUT C.0 'C.0 not used <--------------- C.0 IS PROGRAMMER PIN, DO NOT RE-CONFIGURE
OUTPUT C.1 'C.1 not used
OUTPUT C.2 'MOSFET driver
INPUT  C.3 'Trigger
INPUT  C.4 'C.4 not used

Low C.2 'FAN/MOSFET OFF ensure on power up
Main:
Do
 Do : Loop until PinC.3=1  ' pinC.3 = 0 then Low C.2 FAN/MOSFET OFF
 pause 1000
loop
gosub Timx  ' wait 2 min before FAN/MOSFET ON
do
 If pinC.3 = 1 then High C.2 ' Trigger High FAN/MOSFET ON
   pause 1000
   loop <-------------------------- WHAT IS THIS DOING HERE ?
 else  ' Trigger has gone Low
   gosub Timx  ' Fan continues for 2 min
   Low C.2  'FAN/MOSFET OFF
   gosub Main
 endif
<-----------------------------LOOP MUST BE HERE ???

Timx:
for x=1 to 5 ' 1 to 120 for 2 min - 5 for test purposes
 pause 1000
next x
return