Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 00:13 31 Jan 2026 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : Firmware for CMM2

Author Message
calcmandan

Newbie

Joined: 24/07/2020
Location: United States
Posts: 9
Posted: 09:49am 25 Jan 2026
Copy link to clipboard 
Print this post

Excuse my ignorance, as I'm new at the whole homebrew homebuilt computer world. My only mainstream computer at home is a raspberry pi 500. Will I have difficulty getting the firmware onto the CMM2 once I get one built?
calcmandan
sysop  : air & wave bbs
finger  : calcmandan@bbs.erb.pw
 
phil99

Guru

Joined: 11/02/2018
Location: Australia
Posts: 2958
Posted: 10:04am 25 Jan 2026
Copy link to clipboard 
Print this post

See the CMM2 manual Appendix G.
Here is the firs few lines.
  Quote  Appendix G – Loading the Firmware
Loading the Firmware
The STM32 processor includes its own programmer/bootloader so the Colour Maximite 2 firmware can be easily loaded via USB using a personal computer or laptop (special hardware is not needed). Just follow these steps.
 
vegipete

Guru

Joined: 29/01/2013
Location: Canada
Posts: 1156
Posted: 12:15am 26 Jan 2026
Copy link to clipboard 
Print this post

The only slightly weird thing you will need is a USB-A to USB-A cable or adapter. I use two USB-A plugs soldered back to back.
Visit Vegipete's *Mite Library for cool programs.
 
JohnS
Guru

Joined: 18/11/2011
Location: United Kingdom
Posts: 4220
Posted: 12:45pm 26 Jan 2026
Copy link to clipboard 
Print this post

To use Linux the manual may have a typo of http instead of https

Should be this

John
 
calcmandan

Newbie

Joined: 24/07/2020
Location: United States
Posts: 9
Posted: 10:06pm 28 Jan 2026
Copy link to clipboard 
Print this post

Thanks for your patient answers.
calcmandan
sysop  : air & wave bbs
finger  : calcmandan@bbs.erb.pw
 
calcmandan

Newbie

Joined: 24/07/2020
Location: United States
Posts: 9
Posted: 10:14pm 28 Jan 2026
Copy link to clipboard 
Print this post

I'll just order a board and go from there. I should have a proper display for it. Got to check the old attic.
calcmandan
sysop  : air & wave bbs
finger  : calcmandan@bbs.erb.pw
 
Print this page


To reply to this topic, you need to log in.

The Back Shed's forum code is written, and hosted, in Australia.
© JAQ Software 2026