Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 09:19 22 Nov 2026 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : Total reset

Author Message
Bryan1

Guru

Joined: 22/02/2006
Location: Australia
Posts: 2302
Posted: 09:25am 21 Nov 2026
Copy link to clipboard 
Print this post

G'Day guy's well I have let my PC3 boards go by the way side so this afternoon after my reset sleep as I am working night shift, flashed V7.00.00RC1 on ans soon had all 4 boards connected and talking with each other over wifi.

So got back onto claude where I asked about webcams so a drive in the morning I'm going to pick to pick up 2 webcams form JBHI and get them working so we can see the local wildlife movements on my farm.

The idea is I use board 1 with the 10" touch screen to be a master now as Claude suggested 2 wifi webcams they will be bought tomorrow so very soon a IP address can see a live webcam where a webcam can be shown on board 1 at my work and my goal is get a video of this huge black snake that is on my farm.

Now claude is is saying RC1 isnt the one I want and V7.00.00 is the one so classification is needed so I setup with the right firmware.

I do have a G2 colour maximite here that needs an update and it is paying for this to be the master but getting it connected does need some add on boards buit thats another day.

Pretty soon with these PC3 boards I will have wildlife pictures coning where I can see a picture if it changes.

This does go can MMBasic show a video as I do want to get a video of this huge blacksnake thart lives on my farm.

It will be fun with claude over the nexct week as I get the3se webcams going so I can try and surprise the sparkie at work with this addition

But guy's I am getting there so next week lets see how this sounds as each waking day can do wonders as I get mu goal of capturing wildfile
 
matherp
Guru

Joined: 11/12/2012
Location: United Kingdom
Posts: 12252
Posted: 04:20pm 21 Nov 2026
Copy link to clipboard 
Print this post

I don't want to dampen your enthusiasm but...

Neither the PC3 nor CMM2 support webcams. The PC3 supports still single image capture from a range of specific camera modules as per the manual but these connect on a parallel bus not via USB
Edited 2026-11-22 02:20 by matherp
 
lizby
Guru

Joined: 17/05/2016
Location: United States
Posts: 3891
Posted: 04:34pm 21 Nov 2026
Copy link to clipboard 
Print this post

A waterproof wifi non-cloud-based PTZ camera may be your best bet. The trick is being sure that your images and control don't go back to China (if that's an issue for you). Sorry but I don't have a recommendation.
PicoMite, Armmite F4, SensorKits, MMBasic Hardware, Games, etc. on FOTS
 
Print this page


To reply to this topic, you need to log in.

The Back Shed's forum code is written, and hosted, in Australia.
© JAQ Software 2026