Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 11:36 12 May 2025 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : Plastic Enclosure

Author Message
rofa
Newbie

Joined: 11/09/2011
Location:
Posts: 2
Posted: 07:34pm 10 Sep 2011
Copy link to clipboard 
Print this post

Can anybody tell me, what type of the plastic enclosure is used for the MM ?
I mean the white/grey box.
Thanks in advance,
Jiri
 
donmck

Guru

Joined: 09/06/2011
Location: Australia
Posts: 1313
Posted: 07:40pm 10 Sep 2011
Copy link to clipboard 
Print this post

  rofa said   Can anybody tell me, what type of the plastic enclosure is used for the MM ?
I mean the white/grey box.
Thanks in advance,
Jiri


I was a little confused on this until Sparkey set me straight two days ago.

For the original board, it is an Altronics HO376 case. Snap together 130 x 75 x 28mm.

But it appears that it may not be listed in the latest catalogue, so I don't know if it can be purchased separately, or still available.

Cheers Don...Edited by donmck 2011-09-12
https://www.dontronics.com
 
ajkw
Senior Member

Joined: 29/06/2011
Location: Australia
Posts: 290
Posted: 10:40pm 10 Sep 2011
Copy link to clipboard 
Print this post

Altronics cat 2011-12 page 233 bottom left corner. Also on the website. Is part number H0376 not HO376, that is zero not O.
 
donmck

Guru

Joined: 09/06/2011
Location: Australia
Posts: 1313
Posted: 10:45pm 10 Sep 2011
Copy link to clipboard 
Print this post

  ajkw said   Altronics cat 2011-12 page 233 bottom left corner. Also on the website. Is part number H0376 not HO376, that is zero not O.


that b him

Cheers Don...
https://www.dontronics.com
 
rofa
Newbie

Joined: 11/09/2011
Location:
Posts: 2
Posted: 05:31pm 11 Sep 2011
Copy link to clipboard 
Print this post

Thank you very much.
Jiri
 
sparkey

Senior Member

Joined: 15/06/2011
Location: Australia
Posts: 819
Posted: 05:55pm 11 Sep 2011
Copy link to clipboard 
Print this post

yes it is still a current stocked item
technicians do it with least resistance
 
Print this page


To reply to this topic, you need to log in.

The Back Shed's forum code is written, and hosted, in Australia.
© JAQ Software 2025