TheBackShed.com

Home	JAQForum Ver 24.01
Log In or Join
Active Topics
Local Time 03:27 08 Jun 2025	Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : Working with usb

Author

Message

Juri74

Senior Member

Joined: 06/02/2012
Location: Italy
Posts: 162

Posted: 03:27pm 20 Feb 2012

Copy link to clipboard

Print this post

Question: is it possible to use the usb port like a serial port? i mean i want to connect my duinomite with my UBW32 using the usb, can i use one of them like a pc and access the other throug the serial function with usb cable?

juri

Olimex
Senior Member

Joined: 02/10/2011
Location: Bulgaria
Posts: 226

Posted: 04:47pm 20 Feb 2012

Copy link to clipboard

Print this post

yes, it's possible DM can be USB host but the current firmware do not support this

Juri74

Senior Member

Joined: 06/02/2012
Location: Italy
Posts: 162

Posted: 04:50pm 20 Feb 2012

Copy link to clipboard

Print this post

thank you Olimex, and do you know if is it possible with maximite basic 3.1 firmware?

Juri

Olimex
Senior Member

Joined: 02/10/2011
Location: Bulgaria
Posts: 226

Posted: 06:51pm 20 Feb 2012

Copy link to clipboard

Print this post

to the best of my knowledge no it's not possible

Juri74

Senior Member

Joined: 06/02/2012
Location: Italy
Posts: 162

Posted: 11:56pm 20 Feb 2012

Copy link to clipboard

Print this post

thank you again Olimex
Juri

djuqa

Guru

Joined: 23/11/2011
Location: Australia
Posts: 447

Posted: 12:26am 21 Feb 2012

Copy link to clipboard

Print this post

Why not just use the Serial ports on both boards to talk to each other
Connected directly the 2 boards should transfer data fast enough for most needs.
Edited by djuqa 2012-02-22

VK4MU MicroController Units

Juri74

Senior Member

Joined: 06/02/2012
Location: Italy
Posts: 162

Posted: 01:10am 21 Feb 2012

Copy link to clipboard

Print this post

djuqa said Why not just use the Serial ports on both boards to talk to each other
Connected directly the 2 boards should transfer data fast enough for most needs.

because i haven't maximite basic on UBW32 but it's native firmware, may i set a serial port on some pins of the ubw32 and use it to send commands?
Juri

Print this page

To reply to this topic, you need to log in.