Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 15:17 29 Oct 2025 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : How to install an uSD card on the CGMMSti

Author Message
DuinoMiteMegaAn
Senior Member

Joined: 17/11/2011
Location: Australia
Posts: 231
Posted: 08:11pm 26 Feb 2012
Copy link to clipboard 
Print this post

The card will not pass over the firmware jumper and the metal crystal?
This must be cruel joke or trick or a serious PCB layout problem?
 
BobD

Guru

Joined: 07/12/2011
Location: Australia
Posts: 935
Posted: 08:27pm 26 Feb 2012
Copy link to clipboard 
Print this post

No, if I recall correctly, the holder opens up like a hinge, you insert the card and then close it back down. CG has written a document on his creation and that may tell all.
 
BobD

Guru

Joined: 07/12/2011
Location: Australia
Posts: 935
Posted: 08:32pm 26 Feb 2012
Copy link to clipboard 
Print this post

Bigmik knows how. Look here http://www.thebackshed.com/forum/forum_posts.asp?TID=4572&PN =4
 
DuinoMiteMegaAn
Senior Member

Joined: 17/11/2011
Location: Australia
Posts: 231
Posted: 08:42pm 26 Feb 2012
Copy link to clipboard 
Print this post

Whew ... gently pull back the SD holder to the edge horizonally to unlock then lift the sd holder hinge up then insert the card. Reverse the process.

edited ...

The CGMMStick is slick Edited by DuinoMiteMegaAn 2012-02-28
 
Print this page


To reply to this topic, you need to log in.

The Back Shed's forum code is written, and hosted, in Australia.
© JAQ Software 2025