Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 15:12 02 Nov 2025 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : Problem with MMBASIC (DOS)

Author Message
BobDevries

Senior Member

Joined: 08/06/2011
Location: Australia
Posts: 266
Posted: 12:31am 26 Apr 2012
Copy link to clipboard 
Print this post

Hi all,

I've been trying out MMBASIC for DOS, and finding a few problems.

It frequently just quits if I type a line number by itself, to kill an existing line, or if I type NEW, to remove the programme in memory.

Anyone else seen this?

Regards,
Bob Devries
Dalby, QLD, Australia
 
TassyJim

Guru

Joined: 07/08/2011
Location: Australia
Posts: 6343
Posted: 07:44am 26 Apr 2012
Copy link to clipboard 
Print this post

I haven't seen your problems but I usually code in MM Edit and run the program once in DOS MM Basic.

I did try to get your errors but 20 or so NEW's worked OK and a similar number of line number entries also worked without fault.

I did find another problem:
The enter key on the number-pad does not work.
The number keys are OK but not the enter key.

Jim
VK7JH
MMedit
 
Print this page


To reply to this topic, you need to log in.

The Back Shed's forum code is written, and hosted, in Australia.
© JAQ Software 2025