Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 00:10 20 Sep 2026 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : MMBASIC Commands & Functions

Author Message
Poppy

Guru

Joined: 25/07/2019
Location: Germany
Posts: 486
Posted: 07:30pm 02 Sep 2019
Copy link to clipboard 
Print this post

Hi Guys,

just opened a general thread for all MMBASIC issues and the sake of organisation.


                                               



My 1st specific question:

Does PRINT USING exist or am I just to dumb to see?

Andre ... such a GURU?
 
twofingers

Guru

Joined: 02/06/2014
Location: Germany
Posts: 1769
Posted: 09:10pm 02 Sep 2019
Copy link to clipboard 
Print this post

  Poppy said  Does PRINT USING exist or am I just to dumb to see?

I would say both.    

Seriously: MMBasic has equivalents/replacements (kind of).
For Maximite Basic (4.5) try FORMAT$(nbr [, fmt$])
and for
MicroMites take a look at STR$(number, m, n, c$).

Regards Michael
Edited 2019-09-03 07:41 by twofingers
‚My name is Ozymandias, king of kings
Look on my works, ye Mighty, and despair!‘
Nothing beside remains. Round the decay
Of that colossal wreck, boundless and bare
The lone and ...
 
Poppy

Guru

Joined: 25/07/2019
Location: Germany
Posts: 486
Posted: 04:57am 03 Sep 2019
Copy link to clipboard 
Print this post

SO there isn´t!


But thanks for your support ...

... I will just check out, otherwise it could be managed by a subroutine.

I just got so used to this in other BASICs.
Andre ... such a GURU?
 
Print this page


To reply to this topic, you need to log in.

The Back Shed's forum code is written, and hosted, in Australia.
© JAQ Software 2026