Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 16:46 10 May 2025 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : PCB Manufacturing : diy pcb plated-through holes

Author Message
isochronic
Guru

Joined: 21/01/2012
Location: Australia
Posts: 689
Posted: 12:08pm 02 Aug 2018
Copy link to clipboard 
Print this post

Anyone tried this method ? Looks like a paste and cure idea, so is similar
to solder paste handling

diy plated through

 
Boppa
Guru

Joined: 08/11/2016
Location: Australia
Posts: 814
Posted: 06:14am 03 Aug 2018
Copy link to clipboard 
Print this post

Havent tried it, might have to as the way I used to do it doesnt seem to be available anymore (the old copper tube system you crimped into the pcb)
 
Print this page


To reply to this topic, you need to log in.

The Back Shed's forum code is written, and hosted, in Australia.
© JAQ Software 2025