Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 07:21 17 Jul 2025 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Windmills : downwind mill

Author Message
brucedownunder2
Guru

Joined: 14/09/2005
Location: Australia
Posts: 1548
Posted: 08:32pm 23 Nov 2008
Copy link to clipboard 
Print this post

Hi Crew,, I would like to know if any of you have a downwind mill running ?.
Do the standard "upwind" blades have to be carved different ?. Or , can one just turn the blades ?.

Any other suggestions,,I see Bryan is interested ,,so I'll be watching his progress..

Bruce
Bushboy
 
Dinges
Senior Member

Joined: 04/01/2008
Location: Albania
Posts: 510
Posted: 09:57pm 23 Nov 2008
Copy link to clipboard 
Print this post

Bruce,

Check out this project by WindstuffEd if you're not familiar with it yet:

http://www.windstuffnow.com/main/test_page.htm

Peter.
 
whiskey

Newbie

Joined: 19/06/2007
Location: Ireland
Posts: 21
Posted: 11:57pm 23 Nov 2008
Copy link to clipboard 
Print this post

No need for any blade changes Bruce.

 
Print this page


To reply to this topic, you need to log in.

The Back Shed's forum code is written, and hosted, in Australia.
© JAQ Software 2025