TheBackShed.com

Home	JAQForum Ver 24.01
Log In or Join
Active Topics
Local Time 21:40 17 Jul 2025	Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Windmills : 200 Watt Jaycar Mill

Author

Message

hydroplasma

Newbie

Joined: 19/12/2008
Location: Australia
Posts: 1

Posted: 06:20am 19 Dec 2008

Copy link to clipboard

Print this post

Hi All,

I just found this site looking for information on Jaycar 200watt mill.

I have a question that I feel is a litle silly but will ask anyway.
Could anyone advise me on how to remove the plastic cover over the alternator from the jaycar mill its the older 200watt 24 volts version, or did the chinaman climb inside to assemble.

Thanks

GWatPE

Senior Member

Joined: 01/09/2006
Location: Australia
Posts: 2127

Posted: 11:54pm 19 Dec 2008

Copy link to clipboard

Print this post

Hi hydroplasma,

you need to remove the yaw bearing first, unscrew, if I remember correctly. This allows the alternator to be slid out from the plastic casing.

Gordon.

become more energy aware

Print this page

To reply to this topic, you need to log in.