TheBackShed.com

Home	JAQForum Ver 24.01
Log In or Join
Active Topics
Local Time 16:29 22 Jul 2025	Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Windmills : My first windmill complete

Page 2 of 2

Author

Message

Smart Drives

Senior Member

Joined: 06/07/2009
Location: Australia
Posts: 115

Posted: 03:07am 13 Aug 2009

Copy link to clipboard

Print this post

Everyone be aware that this link wires up the motor counter clockwise whereas ecoinnovation wire theirs up clockwise this changes the wire numbers when hooking up in delta (this link shows STAR config. though)this is an 80S stator rewired half series half parallel 80SP or
(80-02S-07P-S)
If you want delta dont join wires 1,2&3 together, leave them seperate so when you finish rewiring you have 6 wire ends. With the 6 wires join 3&5, 2&4, 1&6.

http://www.watchtv.net/~rburmeister/smart%20wiring.html

also this site mentions that 60S motors only have 36 poles (new model decogged), the model previous (that hasn't been decogged has 42 poles like 100S and 80S).

email me direct smartdrivesaustralia@gmail.com for other diagram its to big for here.

Cameron.
Edited by Smart Drives 2009-08-14

All smart drive parts sold
Custom built turbine parts on
Multicam flatbed CNC Router

Smart Drives

Senior Member

Joined: 06/07/2009
Location: Australia
Posts: 115

Posted: 03:08am 13 Aug 2009

Copy link to clipboard

Print this post

.Edited by Smart Drives 2009-08-14

All smart drive parts sold
Custom built turbine parts on
Multicam flatbed CNC Router

Page 2 of 2

Print this page

To reply to this topic, you need to log in.