TheBackShed.com

Home	JAQForum Ver 24.01
Log In or Join
Active Topics
Local Time 22:01 22 Jul 2025	Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Windmills : Ametek connected

Author

Message

faroun
Regular Member

Joined: 18/09/2008
Location:
Posts: 62

Posted: 12:47pm 19 Aug 2009

Copy link to clipboard

Print this post

good day all,

Edited by faroun 2009-08-21

Many Ideas One Brain.
http://www.wrapwind.com

Janne
Senior Member

Joined: 20/06/2008
Location: Finland
Posts: 121

Posted: 04:45pm 19 Aug 2009

Copy link to clipboard

Print this post

Hi,

You CAN wire it like that, but it will not work

What you need to do, is connect all the negative leads directly to battery, and connect the positive leads like you have pictured. So that the positile leads are isolated from the battery by the rectifier diodes.

If at first you don't succeed, try again.

My projects

faroun
Regular Member

Joined: 18/09/2008
Location:
Posts: 62

Posted: 06:55pm 19 Aug 2009

Copy link to clipboard

Print this post

ok

thanksEdited by faroun 2009-08-21

Many Ideas One Brain.
http://www.wrapwind.com

Greenbelt

Guru

Joined: 11/01/2009
Location: United States
Posts: 566

Posted: 08:46pm 19 Aug 2009

Copy link to clipboard

Print this post

Faroun;

Janne has instructed you correctly.
this diode set up is 3 phase all circuits are independent
and if the diodes are not blown out (Defective) then there will be no short circuit. the output from the diode bridge
that is normally the big post on the alt'ntr hooks to the +
battery terminal.
Good luck with your project.

Edited by Greenbelt 2009-08-21

Time has proven that I am blind to the Obvious, some of the above may be True?

Print this page

To reply to this topic, you need to log in.