 Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me. |
Forum Index : Windmills : bodgie lenz
| Author | Message | ||||
| gonzo Newbie  Joined: 18/02/2007 Location: AustraliaPosts: 6 |
any input would be appreciated wings 285x140x1500h alum with 5 f/p washer body plate steel ribs arms 479 from wings shaft 42.5 top bearing f209 bottem bearing f/p star wiring oatley k241 tower 25 mm box section steel 350x3500h base (not shown) 1400x1500h x350 pyramid not in location that is 3hrs west at wyangala dam thanks gonzo r/b enterprizes  |
||||
Gizmo Admin Group  Joined: 05/06/2004 Location: AustraliaPosts: 5116 |
Thats a very steep hill there. 
Looks good, how does it run? Glenn The best time to plant a tree was twenty years ago, the second best time is right now. JAQ |
||||
| gonzo Newbie Joined: 18/02/2007 Location: AustraliaPosts: 6 |
it spins but not constant or quick glows a 100 watt spot light orange to yellow lots of trees around no noise to speak of arms are bolted to shaft and rubber mounted with old inner tube long shaft length to allow work on f/p , electrics without lowering will be guyed with steel cable at final location to be used to charge 12volt batt to remote water pump and poss connect to house 24volt system this is 2 week test run before delivery would not have come this far without the help of this site and its members so thankyou next job peltier unit onto esky |
||||
 Print this page |
 |
The Back Shed's forum code is written, and hosted, in Australia. | © JAQ Software 2025 |
