Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 19:59 14 Jul 2025 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Windmills : Mounting the Bearings for Randy’s Weldmen

Author Message
imsmooth

Senior Member

Joined: 07/02/2008
Location: United States
Posts: 214
Posted: 10:14pm 18 May 2008
Copy link to clipboard 
Print this post

I am mounting the bearings using the weldment from Randy's workshop.
Has anyone used this? How are the bearings suppose to stay fixed in place.
The nut on the shaft and the stator will prevent the shaft and bearing from
going from left to right, but what stops the left bearing from sliding out to
the left? I am thinking about cutting a rectangular piece of steel and
fastening it between two pairs of bolts to "lock" the bearing into place.

.Edited by imsmooth 2008-05-20
 
Print this page


To reply to this topic, you need to log in.

The Back Shed's forum code is written, and hosted, in Australia.
© JAQ Software 2025