TheBackShed.com

Home	JAQForum Ver 24.01
Log In or Join
Active Topics
Local Time 22:51 15 Jul 2025	Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Windmills : Motors...Am I correct about this?

Author

Message

Glipski

Newbie

Joined: 26/08/2008
Location: United States
Posts: 10

Posted: 11:34am 05 Sep 2008

Copy link to clipboard

Print this post

Trying to figure this out...

If I had a permanent magnet DC motor that was 180VDC, 1700rpm...then at a usable output from a mill, I'd have maybe 45vdc@425rpms, and 22.5vdc@212rpms...correct?

Am I on the right track with this line of thought?

GWatPE

Senior Member

Joined: 01/09/2006
Location: Australia
Posts: 2127

Posted: 12:54pm 05 Sep 2008

Copy link to clipboard

Print this post

Yes.

The max current will not change, but the power output will be down by the reduced voltage ratio.

Gordon.

become more energy aware

Print this page

To reply to this topic, you need to log in.