Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.
My dad once had a novel idea for a dummy load for a combination hydro/wind setup.
Obtain a largish 4 pole squirrel-cage AC motor, and a similarly sized DC motor that will run from your battery bank(12, 24 VDC, etc).
Put a circuit breaker on the mains side of the AC motor to detect when the grid goes down for maintenance.
When excess power is available, fire up the AC motor, which will start spinning the DC motor. Start ramping up the drive voltage to the DC motor, until it tries to spin faster than the mains driven one.
Pour all the excess power you can get into the DC motor, and see the wattmeter fly backwards!
Sure, each motor is only 80% efficient, but if the power's going to waste anyway...
Nigel Weeks
nweeks at karbonit dot com
davef Guru Joined: 14/05/2006 Location: New ZealandPosts: 499
Posted: 09:08am 02 Apr 2007
Copy link to clipboard
Print this post
And possibly electrocute the linemen trying to restore your power system!
Reading about approvals for commercial grid-tied inverters is in order.