Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 16:48 23 Aug 2025 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Electronics : using  a MPPT solar control on a wind turbine?

Author Message
rgormley
Senior Member

Joined: 22/02/2006
Location: Australia
Posts: 245
Posted: 02:30am 07 Jun 2020
Copy link to clipboard 
Print this post

I have a MPPT EP solar 4210RN feeding my 24V bank from 500W of solar
all happy and working
specs: 100V DC input 1000W at 24V (40AMP)


QUESTION: i have bought a 48v 500w 6 blade aliexpress cheap 500watt wind turbine.
Can i run the DC output (after the 3 phase bridge rectifier) into the solar charge controller (4210RN) effectively in parallel with the solar panel input)via the wind turbines 3 phase bridge DC out

or should i keep the turbine separated and just feed it straight to the batt bank?

** oh and i will have a over voltage sense cct that activates a dump load on the ac side of the turbine if the volts get up to 28~29v on the bat bank (has time based hysteresis to stop rapid cycling)

Thanks
 
Print this page


To reply to this topic, you need to log in.

The Back Shed's forum code is written, and hosted, in Australia.
© JAQ Software 2025