Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 11:13 10 May 2025 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Wanted : Twisting the stator fingers

Author Message
leftcliq
Regular Member

Joined: 21/07/2012
Location: Australia
Posts: 51
Posted: 12:30pm 09 Jul 2013
Copy link to clipboard 
Print this post

Hi Guys,

I have a F&P Type 4 cogless smart drive and I am trying to get the rotor to be as frictionless as possible. I have replaced the bearings. Has anyone tried to twist the fingers on the stator so that the rotor is easier to turn? If so, what technique did you use? Will this work with the type 4 stator? Is there any reduction in output?

Regards,
Dale.
 
Print this page


To reply to this topic, you need to log in.

The Back Shed's forum code is written, and hosted, in Australia.
© JAQ Software 2025