 Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me. |
Forum Index : Microcontroller and PC projects : I've found an interesting module for I2C
  Page 2 of 2 |
|||||
| Author | Message | ||||
| scruss Regular Member  Joined: 20/09/2021 Location: CanadaPosts: 95 |
At least Qwiic and Stemma QT use the same pinout. Wemos/LOLIN have been producing boards with a JST 1 mm I²C connector for years (possibly at least as long as SparkFun's Qwiic) and it has SDA/CLK swapped w.r.t. Qwiic/Stemma QT. And only two standards? There's also Grove, (full-size) Stemma, Octopus (2.54 mm pitch) and a few others, all vying to be the easy-connect standard. |
||||
Mixtel90 Guru  Joined: 05/10/2019 Location: United KingdomPosts: 8245 |
The nice thing about standards is that there are so many of them to choose from. :) Mick Zilog Inside! nascom.info for Nascom & Gemini Preliminary MMBasic docs & my PCB designs |
||||
| JohnS Guru Joined: 18/11/2011 Location: United KingdomPosts: 4106 |
And if you wait a little more come along. John |
||||
| Mixtel90 Guru Joined: 05/10/2019 Location: United KingdomPosts: 8245 |
It's always better to create your own, I've found. At least no-one can tell you that it's non-standard. :) Mick Zilog Inside! nascom.info for Nascom & Gemini Preliminary MMBasic docs & my PCB designs |
||||
| Page 2 of 2 |
|||||
 Print this page |
 |
The Back Shed's forum code is written, and hosted, in Australia. | © JAQ Software 2025 |
