Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 09:44 06 Feb 2026 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : MMEdit V5.3.4

     Page 4 of 4    
Author Message
Turbo46

Guru

Joined: 24/12/2017
Location: Australia
Posts: 1660
Posted: 05:54am 22 Jan 2026
Copy link to clipboard 
Print this post

Thanks Jim  
Keep safe. Live long and prosper.
 
panky

Guru

Joined: 02/10/2012
Location: Australia
Posts: 1117
Posted: 03:10am 25 Jan 2026
Copy link to clipboard 
Print this post

Hi Jim,
Would it be possible to add the version number to the download box on geoff's site?

Secondly, running Linux Mint 22.2 Cinnimon, MMCC likes to take over complete control both during upload and if anything is happening in the monitor window ( won't even just stay in it's own workspace)? Could this be a focus issue in my config?
Regards,
Doug.
... almost all of the Maximites, the MicromMites, the MM Extremes, the ArmMites, the PicoMite and loving it!
 
TassyJim

Guru

Joined: 07/08/2011
Location: Australia
Posts: 6443
Posted: 04:31am 25 Jan 2026
Copy link to clipboard 
Print this post

  Quote  Would it be possible to add the version number to the download box on Geoff's site?

Sorry.
Geoff has kindly supplied the space on his website and one requirement is that I am restricted to the one file which retains the same name.

  Quote  MMCC likes to take over complete control

It sounds like MMCC is using too much CPU. This probably means that you are sending data at a high rate.
Try this test program
'
n = 1
DO
PRINT "fred",STR$(n)
PAUSE 100
INC n
LOOP

While running 'top' or similar, change the PAUSE to a smaller value and watch the CPU utilisation.
On my old Linux box, I can run other programs without any obvious issues with MMCC using 50%+ CPU

MMCC is not good at handling high data rates.

If you regularly send high volumes of data, perhaps a better terminal program is needed.

Try Rob's GFXterm


Jim
VK7JH
MMedit
 
     Page 4 of 4    
Print this page


To reply to this topic, you need to log in.

The Back Shed's forum code is written, and hosted, in Australia.
© JAQ Software 2026