Posted: 05:49pm 15 Nov 2026 Copy link to clipboard
analog8484 Senior Member
Interesting. I didn't know the LEM sensors can be permanently affected like that.
Totally agree it's not time yet to focus on such things. Just curious if it's something to keep in mind as potential cause of odd behavior.
I had thought about such self calibration that the inverter could do periodically or during startup. I think it would probably require more switches/relays (e.g. disconnect the output, connect the sensor inputs to ground, etc.).
Posted: 06:14pm 15 Nov 2026 Copy link to clipboard
analog8484 Senior Member
Congrats on a great milestone. Great to see it working with the dreaded hair drier load. The waveform is much nicer than what Keepis posted for his hair drier IIRC. Perhaps Keepis could test soon.
I believe the control enhancement for unbalanced loads is now better than what's available in many commercial LF inverters including Victron and Schneider. Assuming the required add-on HW components are cheap enough at scale, I would not be surprised if it shows up in Chinese LF inverters in the near future Edited 2026-11-16 04:16 by analog8484
Posted: 10:42pm 15 Nov 2026 Copy link to clipboard
phil99 Guru
Re the current sensor zero offset. A partial solution may be at power-up, before driving the MOSFETs, measure and save the current sensor output. This wont fix drift that occurs while running, so not much help for an inverter that is running all the time as the high peak current of motor starts will likely cause a change in offset, but for a standby inverter may be of some value.
An a place to start experimenting for a fix while running might be to compare the positive and negative peaks. When they are "almost" the same assume they are actually exactly the same and set the zero current point halfway between. Defining "almost" may be tricky.
A possible explanation may be turbulence in the airflow combined with a significant temperature coefficient of the resistance wire in the element. Fluctuations in the airflow will vary the rate of cooling of the wire causing the resistance to vary. Nickel and chromium are getting expensive so perhaps cheaper alloys are being used in consumer products. For it's intended purpose such fluctuations don't matter.
Posted: 06:14am 16 Nov 2026 Copy link to clipboard
poida Guru
Phill99: I like that idea (before AC PWM, get primary winding current sensor zero)
everyone: the last test was with a a hair drier but this one does not use diodes to reduce power at full power setting. I had to simulate this by using the switched inline diode when running it at FUL POWA! It was nice to see this idea scale from 100W to 400W to 1000W+