Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 03:48 12 Sep 2025 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.
Forum Index : Windmills
  Topics Started By Replies Views
Last Post By
Sticky Topics        
Forum upgrade Gizmo, 05/07/2019 310 181783 NomadAU  09:32pm 01 Sep 2025
Forum Guidelines Gizmo, 11/12/2011 2 500533   02:49pm 16 Dec 2015
Normal Topics  

   Page 29 of 98    

Blade hub ajcmbrown, 13/07/2011 25 9456   12:56pm 23 Jul 2011
Optimum angle of guy wires? domwild, 18/07/2011 7 11016   10:00am 22 Jul 2011
2000 watt possible?? MeSoDumm, 22/07/2011 3 3909   01:13am 22 Jul 2011
Which are better magnets the round or MeSoDumm, 21/07/2011 2 3059   10:48pm 20 Jul 2011
No Forum Smokey5159, 11/07/2011 10 3987   10:40pm 18 Jul 2011
How to get equal prop angle? domwild, 17/07/2011 3 4422   11:03pm 17 Jul 2011
Help please Smokey5159, 10/07/2011 7 4816   08:05pm 17 Jul 2011
My new mill VK4AYQ, 06/09/2010 176 156148   03:55am 16 Jul 2011
What is this? AMACK, 04/02/2011 10 4972   05:15am 15 Jul 2011
grid tie inverter for windmill Xmaswiz, 10/06/2011 20 9399   09:56pm 11 Jul 2011
12 or 24 Volt car alternator mill? VK6MRG, 10/07/2011 7 5726   11:15am 11 Jul 2011
VAWT WALL rissole, 10/07/2011 1 3623   10:22pm 10 Jul 2011
White Pointer AXFX Trev, 05/01/2011 55 54775   03:16pm 10 Jul 2011
PhillM dual kicking butt for KarlJ! KarlJ, 10/07/2011 2 3359   01:24pm 10 Jul 2011
Wind turbine noise solution barrygun, 03/07/2011 10 6466   04:28pm 09 Jul 2011
Little help please i8unwo, 29/06/2011 3 4504   01:00pm 09 Jul 2011
Going were no turbine has gone before Tow BobMann, 09/07/2011 2 3888   12:38pm 09 Jul 2011
An answer if I may Smokey5159, 09/07/2011 3 3851   12:40am 09 Jul 2011
inverterless solution vawtwindy, 04/07/2011 3 4075   09:06am 04 Jul 2011
Vawt - grid / mains connection Ynot, 03/07/2011 6 3883   09:02am 04 Jul 2011
cutting Magnets brucedownunder2, 07/06/2011 6 5330   11:47pm 02 Jul 2011
To re-wire or not re-wire Smokey5159, 02/07/2011 3 3337   11:10pm 02 Jul 2011
Simple Windmill/Solar controller bertech, 27/06/2011 3 3295   01:48pm 01 Jul 2011
What set-up? Smokey5159, 28/06/2011 5 4519   04:00pm 30 Jun 2011
Installation red tape Rastus, 24/06/2011 17 5435   02:20pm 30 Jun 2011
= New posts since you last visited .      

   Page 29 of 98    

The Back Shed's forum code is written, and hosted, in Australia.
© JAQ Software 2025